Hi,

I hope everyone is doing well.
We are seeing an issue with XTREE property sheets in ATE version 6.5.1626.0. Everything looks fine with version 6.5.1723.2.
The property sheet has an extra column and an extra row. The extra row in this case has a 1 as the value (see photo.) I can send more info if needed.

Thanks,
John Andreasen

We're enjoying(?) a lot of precipitation, but are still holding our ground out here.

Looks like this problem was introduced as part of a fix in 1723.4 for an issue raised by your colleague Stephen. Obviously it wasn't properly with property sheets. I think I have it fixed, but need to tie up some other loose ends related to possible improvements to ordered maps.. I'll could try to post a patch tomorrow, depending on your degree of urgency.

That is good to hear. There is no real urgency for this as I believe everything still works if you ignore the extra rows/columns. Thanks for pointing out the ordmap thread as I have not been following it and would appreciate enhancements in that area.

Good, thanks. I'll keep working on taming the ordmap2 monster. It has a long way to go, but I'm hoping to get to a point soon where there's enough functionality to allow some experimentation without breaking anything else.

I think this issue has been resolved now in 6.5.1727.0 (ATE), available for beta testing here...

ash-6.5.1727.0-w32-upd.zip
ash-6.5.1727.0-w32c-upd.zip
ash65notes.txt

OK, thank you Jack. Good luck with the ordmap2 enhancements!